Industry updates, technical guides, compressor troubleshooting, and practical content for refrigeration professionals.
222 published articles
Liquid slugging can break valves, wash oil away and destroy a refrigeration compressor quickly. Understanding the causes helps reduce repeat failures and wrong replacements.
Read Article
Keeping the right refrigeration compressor spare parts available can reduce downtime, protect stock and speed up repairs when a cold room or commercial system suddenly stops.
Read Article
A Frascold compressor running with high discharge temperature is often exposing a system condition rather than an immediate internal failure. Condensing pressure, poor return gas cooling, underfeeding, wrong charge behavior and compression ratio all need to be checked before replacement.
Read Article
A Bitzer semi-hermetic compressor that trips on oil pressure is not always facing an internal mechanical failure. Many alarms start with diluted oil, unstable crankcase conditions, blocked filters, wrong differential settings or weak oil return from the system.
Read Article
A Panasonic scroll compressor in low-temperature refrigeration should not be condemned too early. Many repeat failures start with wrong model selection, unstable superheat, dirty heat exchangers, voltage problems or poor oil return around the compressor.
Read Article
Panasonic scroll compressors are searched both by brand and by former Sanyo model codes. A better replacement decision starts from application temperature, refrigerant, power supply and exact model family, not only from nominal horsepower.
Read Article
When a Copeland scroll compressor starts and stops too frequently or trips protection devices, the root cause is often outside the compressor itself: control settings, charge instability, airflow issues, phase problems or wrong capacity balance in the system.
Read Article
Many Copeland scroll compressors lose efficiency or reliability because superheat, return gas cooling, oil return and airflow are only checked roughly. A structured field checklist helps installers optimize performance without stressing the compressor.
Read Article
A new cold room compressor should not be started blindly. Refrigerant selection, oil type, wiring, crankcase heating, superheat and control settings all need verification before the first stable run.
Read Article
After a compressor burnout, replacing the compressor alone is not enough. Acid, carbon residue, degraded oil and moisture can quickly destroy the replacement if cleanup is incomplete.
Read Article
When a replacement scroll compressor fails too soon, the problem is usually procedural: wrong model selection, poor cleanup, bad evacuation, incorrect startup practice or controls left out of range.
Read Article
Liquid floodback, low superheat, poor oil return, voltage issues and repeated short cycling are among the most common reasons a scroll compressor fails, including many Copeland scroll units in the field.
Read Article